Claire Crompton

Claire Crompton has worked in the knitting industry for almost 20 years. After a Knitwear Design degree she became a pattern designer for major yarn manufacturers such as Sirdar and DMC. This is the sixth book in The Knitter's Bible project series, following Knitted Bags and Knitted Accessories.

Kutipan

Jen602membuat kutipan2 bulan yang lalu
3 Once all stitching is complete, make up into a patch as follows. Fuse the iron-on interfacing to the wrong side of the embroidery according to the manufacturer’s instructions. Trim the Aida to within eight blocks of the embroidery all round. Fold six blocks to the back all round and tack (baste) into place. Pin and tack the patch into place on the felt and sew around all sides. Remove tacking and trim the felt to within 1cm (⅜in) of the embroidery. Finish by using double-sided tape to stick the patch to the album.
Jen602membuat kutipan2 bulan yang lalu
3 Once all stitching is complete, make up into a case as follows. Trim the embroidery to 14cm (5½in) high and 21cm (8¼in) wide, making sure the design is in the centre. With right sides facing, place the embroidery and smaller fabric piece together. Using a 1.3cm (½in) seam allowance, sew around three edges, leaving one short edge open. Turn through to the right side and press
Jen602membuat kutipan2 bulan yang lalu
3 Once all stitching is complete, make up into a case as follows. Trim the embroidery to 14cm (5½in) high and 21cm (8¼in) wide, making sure the design is in the centre. With right sides facing, place the embroidery and smaller fabric piece together. Using a 1.3cm (½in) seam allowance, sew around three edges, leaving one short edge open. Turn through to the right side and press, pushing out corners. Turn 1.3cm (½in) to the wrong side around the open edge and tack (baste) in place.
4 To make a lining, fold the larger fabric piece in half to make a piece 12.5cm (5in) deep. Sew around two sides, leaving one short edge open. Turn 1.3cm (½in) to the wrong side around the open edge and tack (baste) in place. Wrap the piece of wadding (batting) around the lining, matching raw edges. Tack the wadding in place, working next to the stitching line in the lining’s seam allowance. With wrong sides facing, insert the lining and wadding into the outer case, matching side seams. Slip stitch the lining to the outer case around the open edge and remove tacking when finished.

Kesan

Jen602membagikan kesanbulan lalu
👍Layak dibaca

  • tidak tersedia
    Claire Crompton
    Naughty but Nice Cross Stitch
    • 7
    • 17
    • 1
    • 1
    en
  • fb2epub
    Seret dan letakkan file Anda (maksimal 5 sekaligus)